I posted about problems with using NEAT to make a luma composite below. I'm having 2 more issues since then but I admit that I still haven't upgraded from 6.04 to 6.05. I'm trying to check with users first to make sure it is all stable.
1 - I suddenly now find that the window I open to adjusted the parameters is lodging itself on the upper left corner of my laptop screen ( I use a laptop with a Dell 2405) and the top and left side of the window are out side of the visible screen . Thus I can't get get to the menus on the top0 of the window which I need to adjust parameters, and I cabn't get my arrow onto the top of the window to pull it down.
I've had this problem before sometimes with a window that gets too big and I can't reach the lower left to pull it smaller, or the top of a window hides underneath the apple menus so i can't grab it.
This one has me frustrated though, Isn't there another way to move a window without grabbing it from the top?
2 - The other weird thing this has been doing is I set it to export HDV to Pro Res 422 walk away and when i come back I may find that even after the render has been completed the CPU is doing it again apparently over and over until I cancel the render window. The only way i figured this out was to look at my destination and was surprised to see it was already done while I had active render window on my running on my screen. It didn't seem to make more than one version but I had apparently extra render files (big ones ) on my hard disk.
is this a bug with 6.04 or this particular plug-in?
Thanks Lenny
Anyway